15HP Reciprocating Air Compressor - 120 Gallon (RS15)

The RS15 is a 15 HP two-stage reciprocating compressor built for continuous commercial and industrial duty in workshops, fabrication plants and service facilities. It delivers 51 CFM @ 175 PSI and can be wired for 208-230V/460V three-phase power at 60 Hz. Typical current draw is 42A @ 230V; 21A @ 480V. Its two-stage cast iron pump uses Swedish steel valves and needle bearings at both ends of the crankshaft, and the valves can be reached without removing the cylinder heads. An enclosed belt guard houses an aftercooler, an automatic tank drain clears condensate, and a low-oil monitor shuts the unit down before the pump can run dry. The motor is an industrial unit with a factory-mounted, pre-wired magnetic starter and UL-listed controls. The drive motor is a totally enclosed, fan-cooled (TEFC) three-phase unit. Start and stop are automatic, with a centrifugal unloader that takes load off the motor at each restart. Compressed air collects in a powder-coated, ASME-tested 120 gallon receiver; the tank sits horizontally for a low profile. A tank discharge ball valve, stainless steel flex lines and a heavy-duty intake filter are all included.